Author Topic: Inline filter and isolation  (Read 1587 times)

BSartist

  • Newbie
  • *
  • Posts: 18
  • Karma: +0/-0
Inline filter and isolation
« on: December 16, 2015, 10:34:59 PM »
If I put the MTU and ECC on its own circuit behind an inline filter, will that prevent all TED PLC from getting to the rest of the house? In other words can I use that setup to protect my X-10 from getting clobbered?

tmarks11

  • Newbie
  • *
  • Posts: 17
  • Karma: +0/-0
Re: Inline filter and isolation
« Reply #1 on: January 15, 2016, 11:55:54 AM »
yes, that will work.

breaker -> filter -> MTU -> outlet -> gateway.  All on its own circuit works beautifully.  I get skip rates of 0.01-0.7% with that setup.  Previously I was about 7% skip.

bperrybap

  • Newbie
  • *
  • Posts: 9
  • Karma: +0/-0
Re: Inline filter and isolation
« Reply #2 on: February 08, 2016, 11:01:40 PM »
yes, that will work.

breaker -> filter -> MTU -> outlet -> gateway.  All on its own circuit works beautifully.  I get skip rates of 0.01-0.7% with that setup.  Previously I was about 7% skip.

Don't you really mean:

Code: [Select]
                      +----MTU
                      |
breaker--->Filter-----+
                      |
                      +---outlet--->gateway

As the the signal/power from the filter goes to both the MTU and the house wiring.